5
ATR-7014 User Manual
EN
HAIR CUT
SERVICING PROCEDURES
and allow to rest about 10 minutes and lubricate oil to the cutting edge. Continuous
use of the unit for over 20 minutes may cause deterioration of cutting performance.
•Do not charge the unit if room temperature exceeds 40°C or drops below O°C
Extreme temperatures will shorten battery life.
1. Clip the lower part of the back.
•Mount the cropped hair attachment one size smaller than the cropped hair
attachment used for close cropping. 9mm for side trimming against 12mm for close
cropping. •Clip the lower part of the back by gradually moving the clippers away from
the head skin 6mm against 9mm.3mm against 6mm.
2. Trimming along the ears.
•Remove the cropped hair attachment. Put the blade edge lightly against the skin and
move it in a circle in the arrow •Hold the ear by hand to facilitate the job.
3. Side trimming
Put the blade edge at right angles to the skin to trim the hair.
4.Shaving downy hair Put the blades directly on the skin and shave the downy hair
working from the lower to the upper part of the neck.
NOTE: Do not press the blades too hard.
TRIM-UP
1. Cutting of crown.
Pull up hair between fingers directly perpendicular to top of head and slowly run the
unit above fingers to cut. •To ensure cutting at the same length, take up hair already
cut together with hair to be cut and cut latter to the same length as the former.
2. Layering and shaping: Lift up hair from the bottom with a comb. Hold comb firmly
in place and cut the hair in the direction of the arrow.
3.Trimming along the ears: Put the blade edge lightly against the skin and move it in a
circle in the arrow direction. •Hold the ear by hand to facilitate the job.
4. Side trimming: Put the blade edge at right angles to the skin to trim the hair.
5.Shaving downy hair: Put the blades directly on the skin and shave the downy hair
working from the lower to the upper part of the neck
• Always clean out hair and lubricating oil unit after use. 1.Always turn switch to(OFF/
CHARGE) before servicing the unit. 2.Use accessory cleaning brush to clean out hair
from the unit and around cutting edge 3.Remove the blade from the unit and clean
out hair from the inside. 4.Lubricate the blade with a few drops of oil. •Store the unit
in a dry place.
