-7-
•Connect the black or brown wire to the Si5580 “L” terminal of the AC power connector. That is the
line, or “hot” connection.
•Connect the white or blue wire to neutral. That’s the “N” terminal.
•Finally, and most importantly, connect the green wire to the GND terminal. That connects the
Si5580 metal enclosure and DC power supply ground to earth ground.
Always unplug the line cord from the wall before attaching it
to the Si5580
k
c
al
b
et
i
h
w
n
e
e
r
g
To Earth Ground
To Neutral
To Line (Hot)
To Earth Ground
To Neutral
To Line (Hot)
green
black or brown
white or blue
"Old Style"
AC Power Plug
"New Style"
AC Power Plug
Installing an AC Line Cord
Remove about 5 mm (3/16 inches) of insulation from each of the three wires of your line cord. (That’s
right, three wires. For safety, always use a three wire power cord on anything with a metal case.)
Depending on where you got your power cord, it may have black, white and green wires or brown/
blue/green.
The AC power plug that was shipped with your Si5580 might be one of two types. The “old style” is
shown in the diagram below, on the left. The “new style”, shown on the right, comes with an insulat
-
ing rubber boot.
Make sure you follow the proper sketch for your connector style.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
