Applied Comfort VI20HA09K25E6PA30, Installation Instructions & Owner'S Manual

Page: 6 / 20

INSTALLATION INSTRUCTION
Electrical Requirement
WARNING
To avoid the risk of property damage,
personal injury or fire, use only copper
conductors.
To avoid property damage, personal injury
or death due to electrical shock, do not use
an extension cord with this unit.
WARNING
To avoid the risk of property damage,
personal injury or fire do not install with
power cord stretched or under a strain as
this may create loose plug/receptacle
connection.
WARNING
To avoid the risk of personal injury, wiring
to the unit must be properly polarized and
grounded.
WARNING
-
5
-
WARNING
HIGH VOLTAGE
Disconnect all power before servicing or
installing this unit multiple power sources
be present , failure to do so may cause
property damage , personal injury or death.
Do not service this unit without first
shutting off the power to the unit form the
circuit breaker and/or removing the unit
cord set plug from the wall outlet.
The power cord is located inside the electrical
control box cover for insert mounting.
LCDI Power cord
All wiring , including installation of the receptacle,
must be in accordance with the NEC, CEC and local
codes ordinances and regulations , as applicable.
LCDI power Cord
Unit Voltage
Rating Minimum Maximum
230/208 187 253
265 238 292
Operating Voltage
Voltage Utilization Range
230
/
208V 15Amp
Perpendicular
230
/
208V 20 Amp
Large tandem
230
/
208V 30Amp
WARNING
To avoid the risk of property damage, personal injury
or death due to fire, ensure that the Case, Unit, and
Front Case Panel are replaced as a complete assembly
in a retrofit/ replacement situation. Do not under any
circumstances insert this Unit into an existing
competitor case. For example, some existing cases
may contain plastics that are incompatible with this
unit from a safety standpoint.
• LCDI Cords
(
230
/
208V models only
)-
Underwriters Laboratories and the National Electric
Code (NEC) now require power cords that sense
current leakage and can open the electrical circuit to
the unit on units rated at 250 volts or less. In the event
that unit does not operate, check the reset button
located on or near the head of the power cord as part
of the normal troubleshooting procedure.
•
Cord connection to a wall socket is not permitted
for 265V units
.
All 265V units must be hard wired
using the hard wire kit.