-
13
-
(5a)Install And Ground The Unit To
The Case Unit Installed Through
Front Of Case
1. Slide the back of the unit into the case. Push the
unit all of the way into the case until it stops.
NOTE:
Either of the case sides may be
removed to enable the unit to be
slid into the case.
2. Ground the unit to the case by installing the front
case-to-unit
.
paint-scraping screws
(5b) Install And Ground The Unit To
The Case Unit Installed Through
Side Of Case
Inside
wall
metal duct
Air
discharge
outlet
(6)Connect The Top Duct
1. Install the duct onto the air discharge outlet.
2. Secure the top duct to the unit by turning the
four case top duct adjusting screws
clockwise
until they are tight.
Use a field supplied clamp to lock the top duct
to the case.
(7)Final Check
Review this Checklist before restoring power.
•
Correct line voltage?
•
Single circuit only?
•
Ductwork connected?
•
Case and wallplenum leveled to specification?
•
Wall plenum caulked? Flashing?
•
Drain connected?
•
Unit wired correctly?
(8)Connect Power
1. If all the above items are correct, turn the power
on at the main service panel.
2. Turn the unit power switch, on the front of the
unit.
side screws
paint-scraping
screws
side screws
(may be installed
on either side)
paint-scraping
screws
paint-scraping screws
Case top
duct adjusting
screws
metal duct
Clamp
