9
TEMPERATURE CONTROL KNOB
The temperature control knob must be removed before
installing chassis into sleeve to gain clearance between
sleeve and chassis (See Fig. 8).
9
Carefully push chassis into sleeve until chassis flange,
(with seal) contacts the flange in the sleeve. (See Fig. 9).
All 3 chassis flanges must be installed in their proper
orientation.
Press on the chassis to make sure seal is in good contact
with sleeve surface.
FIG. 9
FIG. 8
LINE CORD
Plug in line cord to previously installed receptacle, on the
wall or within a subbase.
Fold excess line cord into area between sleeve and
chassis.
FIG. 10
INSTALLING CHASSIS
Center chassis in the sleeve and insert into pre-installed
sleeve.
CAUTION
Be very careful when installing chassis into sleeve to
prevent damage to controls.
Summary of Contents for CM Series
Page 12: ...12 ...
