Applied Comfort CM Series, Installation & Operation Manual

Page: 7 / 12

Use hole closest
to flange.
Flange facing
back of unit.
CHASSIS FLANGE INSTALLATION
(Optional Position “A”)
This position will be used in a small number of sleeves
currently installed to date.
The flange is located 8 5/8 inches from the front of the
chassis.
If old unit is not available, install the left side flange as
described and continue on with “Chassis Installation”, if
the chassis will not fit properly, try “Optional Position “B”
described on the following page.
If unit being replaced is still available, measure distance
from the front of chassis to flange, to determine the
correct position.
Unit is shipped from the manufacturer with the top and
right chassis flange in place.
Install the left side chassis flange using the following
steps:
1. Remove the two screws from the left side of unit where
flange would normally be located.
2. Position chassis flange so the flange is facing the back
of the unit as illustrated in Figure 6.
3. Using the larger set of holes located closet to the
flange end, fasten with screws removed from side of unit
in step “1”.
4. Remove screws holding top and right side chassis
flanges, reverse them to match left side flange and
reattach them to unit.
7
FIG. 6