6.78
Slider
135
6.78
Slider
The Slider module is used to adjust the amplitude of a signal. It acts in the same
way as the Knob module. It has one input and one output. The output signal is the
input signal multiplied by a constant varying between 0 and 2 (+6dB).
Typical Use
The Slider module is used whenever the level of a signal must be adjusted.
Note:
See also Gain, Selector, Volume.
The default values of the following parameter is set at construction
•
gain: default value of the volume gain (value between 0 and 2).
6.79
Static Delay
The Static Delay is a simple delay line with no feedback. Its single input is
the signal to be delayed and its one output is the delayed signal. The delay time
is adjusted with the delay knob on the front panel. The delay can have a maximum
length of 5 seconds. To get a longer delay time, simply cascade multiple Static Delay
modules.
Typical Use
The Static Delay will often be used to delay the gate signal triggering an ADSR
module.
Note:
See also Delay, Sync Delay and Sync Ping Pong Delay.
6.80
Stereo Audio In
The Stereo Audio In module is used to process external audio in Tassman. The outputs of this
module is the left and right signals received from a track or a bus of a host sequencer where the
Tassman has been inserted as an effect. This signal can be then be processed on the fly by Tassman
modules and then sent back to the track or the bus trough the use of an Audio Out or Stereo Audio
Out module.
Summary of Contents for TASSMAN
Page 1: ...USER MANUAL ...
