14
Installing your rangehood
IMPORTANT:
YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR RANGEHOOD
WHETHER TO USE IT IN EXTRACTION MODE OR RECIRCULATION MODE. PLEASE
REFER TO PAGE 17 TO UNDERSTAND THE DIFFERENCES BETWEEN THESE TWO
MODES.
We recommend that at least two people install this rangehood.
If you are using the appliance in recirculation mode, then PLEASE NOTE that all
of the vent in the upper chimney section must be exposed. You will have to
take this into account when calculating the minimum height of the extractor
when installed.
If the recirculation vents are obstructed then the efficiency of the extraction
will be affected and could damage the motor.
IMPORTANT:
YOUR RANGEHOOD SHOULD BE CONNECTED TO YOUR MAINS SUPPLY
AFTER THE REST OF THE INSTALLATION PROCESS HAS BEEN COMPLETED.
1.
The rangehood should be placed at a distance of 65-75cm (26-30inch) from the
cooking surface for the best results.
2.
Drill a hole in the cupboard, 715mm*265mm for 750mm model (GPP75L), and
490mm*265mm for 520mm model (GPP52L). Make sure the distance between
the edge of the hole and the edge of the cupboard edge is at least 35mm.
3.
Take down the filter and remove the four screws on the panel.
4.
Use eight ST4 x 18mm screws to fix the hood into cabinet.
5.
Fix the panel back to the body and install the filter.
6.
Connect the ducting pipe to the outlet.