4
108
C
OPERATION WITH REMOTE CONTROL
Introduction of Function Buttons on the Remote Controller
a
On/off Button:
Push this button to start the unit operation. Push the button again to stop the unit
operation.
b
Mode Button:
Each time you press the button, a mode is selected in a sequence that goes from AUTO
COOL DRY HEAT and HEALTH as the following figure indicates:
AUTO COOL DRY HEAT HEALTH
c
▲
Button:
Push the button to increase the indoor temperature setting to 30ºC.
d
▼
Button:
Push the button to decrease the indoor temperature setting to 17ºC.
e
Fan Speed Button:
This button is used for selecting Fan Speed. Each time you press the button, a fan
speed is selected in a sequence that goes from AUTO, LOW, MED to HIGH, then back to AUTO. When
you select the AUTO or DRY mode, the fan speed will be automatically controlled and you can not set
the fan speed.
f
SLEEP Button:
Press this button to go into the Energy-Saving operation mode. Press it again to cancel.
This function can only be used on COOL, HEAT and AUTO mode and maintain the most comfortable
temperature for you.
NOTE:
While the unit is running under SLEEP operation mode, it would be cancelled if you press the
other button.
g
Swing Button:
Press the SWING button to activate the swing feature. Push the button again to stop.
Press this button to change the swing angle of the louver. The swing angle of the louver is 6
o
for each
press. When the louver swing at a certain angle which would affect the cooling and heating effect of
the air conditioner, it would automatically change the swing direction. No symbol will appear in the dis-
play area when this button is pressed.
ADJUST
AUTO
COOL
DRY
HEAT
HEALTH
HIGH
MED
LOW
MODE
FAN SPEED
DIRECTION
/SWING
TIMER ON
SLEEP
ON/OFF
TIMER OFF
SELF
CLEAN
RESET LOCK
4
3
7
15
16
2
10
14
1
5
8
6
9
SET TEMPERATURE( C)
FOLLOW
ME
LED
DISPLAY
11
CLEAN
AIR
TURBO
13
12
G
NOTE!
• Always aim the remote controller towards the receiver on the indoor unit and make sure there
are no obstacles in between the remote control and the receiver on the indoor unit. Otherwise
the remote control signal will not be picked up by the receiver and the air conditioner will not
work properly.
• The maximum distance at which the remote control will work is approximately 6 to 7 meters.
fig. 3
man_AAC design 11000_1.qxd 07-03-2008 14:22 Pagina 108
