Machine Usage
⚠
CAUTION
To reduce the risk of injury or product damage, read this entire operating manual, with
particular emphasis on the Safety and Preparation sections (Page 4-8), prior to operating the G5Twin.
HIGH-SPEED DIRECT LIQUID PROCEDURE
This recovery method allows for the fastest possible “direct liquid” recovery speeds.
To maximize recovery
rates, be sure to follow all of the Preparing for Operation information on Page 8.
Diagram 5
This recovery method allows for
the fastest possible “direct liquid”
recovery speeds, although the
“vapor” phase of recovery may take a
little longer.
2. Close the Valve Core Removal Tool (VCRT) ball valves at both of the AC/R System Liquid and Vapor ports.
3. Open both valves on the G5Twin, and open both valves on the Recovery Cylinder.
Make sure to completely open the Recovery Cylinder valves to prevent “output restrictions”
(See Tip #1)
.
4. Turn on the G5Twin. The compressor and fan should start.
5. Begin liquid recovery by opening both of the VCRT ball valves at the AC/R System access ports.
6. When all the liquid has been removed: close the Recovery Cylinder Vapor Valve.
7. Continue to run the G5Twin until the EPA-required vacuum is achieved.
8. Close both of the VCRT ball valves.
9. Turn off the G5Twin, then close the valves on the G5Twin.
10. Close the valves on the Recovery Cylinder and disconnect the hoses.
✪
For additional refrigerant recovery tips, see pages 14-17.
A
B
C
1. Setup the G5Twin as shown in
Diagram 5 (below). Make sure that all connections are tight.
A. Connect the AC/R System Liquid Port to the G5Twin input port.
B. Connect the G5Twin output port to the Liquid Port on the Recovery Cylinder.
C. Connect the Cylinder Vapor Port to the AC/R System Vapor Port.
D. Connect a Compound Pressure Gauge to the AC/R System Vapor Port using a T-fitting or
a side-port on a valve core removal tool.
10
G5TWIN OPERATION MANUAL
© 2016 APPION INC. - ALL RIGHTS RESERVED
D
