WARNING
●
Please only use a fully charged battery otherwise damage will be caused.
Also check again that the correct charger was used with the correct battery.
WARNING
●
After setting the housing, confirm that there is a uniform space of
about 0.5mm between the battery housing (head Assy) and the motor
housing (body Assy).
If the space is less than 0.5mm or if the two parts are joined, there is the
possibility of the O-ring coming out of the O-ring groove.
Confirm that this not the case before proceeding.
●
Pull up the lever by finger and check wheter all buckles are locked securely.
(In case of avx, locking buckles are double buckle of both side)
Connect the socket to right way.
Check no gap after setting
Do not set wrong side!
Battery Selection Switch
●
Please confirm that there is no debris adhering to the O-ring, O-ring groove or O-ring connecting surface.
Also confirm that there are no scratches and that an appropriate amount of silicone grease has been used.
①
Check the switch of "Battery Selection Switch"
to same position as the battery type.
②
Place the battery housing (head Assy) carefully in
position taking note that the ribs on the underneath
of the scooter match up.
■
STEP1
Set the battery.
■
STEP2
Set the battery housing (head Assy).
■
STEP3
Checking the housing seal.
■
STEP4
Checking the locking buckle.
①
Please set the fully charged battery in the body housing in the correct position.
③
At this time, confirm that the warning lamp isn't on.
Please do not use the scooter if the warning lamp is on as this may indicate a water
leak has occurred.
②
Next, the battery socket is connected with the body plug.
(Please always remove the connector when not in use or during travel to your destination.)
Checking before use. (setting)
Water Leak Alert Lamp
(All apollo DPV)
15
(Except avx)
●
avx has no sticker of "Battery Selection Switch",
please check the switch to
①
Lithium ion side.
②
①
①
Lithium ion
②
Lead-Acid/Ni-MH
LEAD
-
ACID
Ni-MH
●
When the locking button (square shaped button) is deformed to inside,
pull the button by finger to correct position carefully and check the locking action.
Locking button
