![background image](http://html1.mh-extra.com/html/apluslift/hw-10kbp/hw-10kbp_installation-manual-and-operation-instructions_2953799002.webp)
2
READ THIS MANUAL COMPLETELY BEFORE
INSTALLING LIFT!!!
DISTRIBUTED BY:
Songa Enterprises LLC
8512 122ND AVE NE #25
Kirkland WA 98033
E-mail: [email protected]
Text or Call: 425-429-2699
Website: www.apluslift.com
READ THIS BEFORE INSTALLING THE LIFT!
Improper installation can cause injury or damage!
•
Read this installation and operation manual in its entirety before attempting to install the lift. Manufacturer or
Distributor assumes no responsibility for loss or damage of any kind, expressed or implied, resulting from improper
installation or use of this lift. Always use professional installation companies.
•
All persons using the equipment must be responsible, qualified, and carefully follow the operation and safety
guidelines contained in this manual.
•
A level floor is required for proper lift installation and operation.
•
DO NOT install this lift on any asphalt surface. Only on concrete surface a minimum of 6
”
thick and 3,500 psi tensile
strength with steel or fiber mesh reinforcement.
•
DO NOT install this lift over concrete expansion joints or cracks. (Check with your building architect.)
•
DO NOT install this lift on an upper floor without written authorization from your building architect. Should only be
installed on basement floor.
•
DO NOT attempt to lift only part of a vehicle. This lift is intended to raise the entire body of a vehicle only. This
will bend the arms and void the warranty.
•
DO NOT attempt to use the overhead beam to lift engines, or any other parts out of a vehicle. Doing so will bend the
overhead beam and void the warranty.
•
NEVER lift any persons or vehicles containing persons. This lift is designed to lift empty vehicles only.
Tools For Installation
•
Concrete Rotary Hammer Drill with 3/4
”
Drill Bit
•
Rubber Hammer
•
Chalk Line
•
Sockets and Open Wrench set
•
Ratchet Driver
•
Vise grips
•
Tape Measure
•
Screwdrivers
•
Torque wrench
•
Two 10
’
to 12
’
step ladders
•
4
’
Level
•
12 Inch Crescent Wrench
•
AW32 Non-foaming Hydraulic Fluid (4 gallons)