APF 60298, Instruction Manual, Page: 27 / 79

Thank you for acquiring the heat pump for heating outdoor swimming pools. The experience our company has gained during more
than 20 years in the world of air conditioning of swimming pools has been put to your service in this product, in which we also incor-
porate the technical breakthroughs that turn this heat pump into the equipment that can solve once and for all the air conditioning
of your swimming pool, extending thus the length of your bathing season.
IMPORTANT
We kindly request the client or installer to read this manual carefully in order to:
Complete a correct installation and start-up.
Be familiar with all the potentialities of the unit and to take into account all the necessary circumstances for
its correct and lasting operation.
IT IS SUGGESTED TO TAKE NOTE OF THE FOLLOWING DATA IN ORDER TO
CONTACT WITH THE AFTER SALES SERVICE
INSTALLATION COMPANY
DATE
TELEPHONE
MODEL
CODE
SERIAL NUMBER NS
Dealer’s stamp Installer’s stamp
2. ADDITIONAL RECOMMENDATIONS.
Pressure Equipment Directive (PED-97/23/EC)
A. Installation and maintenance
- In the event of any intervention in the unit, installation, start-up or maintenance, the personnel in charge of these operations must
be familiar with both the instructions and recommendations contained in the installation manual and the elements of the project. -
The personnel in charge of the receipt of the unit will perform a visual inspection in order to verify the possible damages suffered in
the transport: refrigeration circuit, electrical cabinet, frame and housing.
- It is prohibited to place the unit near:
• Heat sources • Flammable materials • Building air intakes
- The unit must be installed, started-up, repaired and maintained by qualified personnel according to applicable regulations and
laws.
- During installation, repairs and maintenance piping should not be tread on or used as a support, otherwise the piping could break
and the R410A gas could cause severe burns.
- During maintenance of the unit, the composition and state of the gas will be revised as well as possible oil stains (leaks in the
refrigeration circuit).
- During the annual maintenance revision of circuit water tightness according to regulations, verify that the high-pressure and low-pressure
controllers are properly connected to the refrigeration circuit and that they switch off the electrical circuit in case of failure.
- Once a year, before starting to use your haet pump again, check the electrical connections of the electrical components. Do this with the heat
pump disconnected from the power supply.
- In the event of any manipulation or intervention on the refrigeration circuit, it is obligatory to switch off the unit and wait several minutes before
puncturing pressure gauges or measuring temperatures. Some elements such as the compressor and pipes can reach high temperatures and high
pressures that can lead to important burns.
27
PacMAGIC HEAT PUMP
1. INTRODUCTION
en
gli
sh