11
A
P
E
X
D
I
G
I
T
A
L
H
T
1
0
0
NOTICE
• Do not connect the PCM/BITSTREAM jack of the HT-100 to the AC-3 RF input of a Dolby Digital receiver. Instead, connect to the
“DIGITAL” or “COAXIAL” input of a Dolby Digital/DTS receiver or Processor. The input of the A/V receiver is not compatible with the
PCM/BITSTREAM jack and is primarily for Laserdiscs only.
• Connect the PCM/BITSTREAM jack of the HT-100 to the "DIGITAL" or "COAXIAL" input of a Dolby Digital/DTS receiver or
Processor.
• Refer to the manual of the connected TV.
• Turn off the power and unplug both units before setting up any connections.
• Due to the wide dynamic range of sound output of the HT-100, adjust the volume of your receiver to a comfortably modest listening
level to avoid any speaker damage.
Connecting to Optional Equipment
To VIDEO OUT
HOW TO SETUP THE DIGITAL AUDIO OUTPUT
To Digital Audio Out
1.Press the STOP button then Press Setup button on the
Remote Control.
2.Press the Right Arrow Key button to highlight the
Audio setting and press the Enter button to select.
3.Select DOLBY DIGITAL/DTS Analog Out column using
the Down Arrow Key. Make sure the display is set to Off.
4.Select DOLBY DIGITAL/DTS Digital Out Column,press the
Enter button continually unit it displays RAW.
5.Press Setup again to Exit.
