Apex Digital 180413, Operation Manual, Page: 21 / 67

20
4. Raise the table manually using the
handwheel (Figure 13) until the panel
or set up block contacts the pressure roller.
5. Make sure the pressure at the right and left
side of pressure roller is even.
6. If adjustment is needed, release the lock nut
( Figure 14 ) with a 14mm wrench.
7. With another 14 mm wrench ( Figure 14 )
adjust other hex nut . Rotate the
hex nut clockwise to raise that side
of the pressure bar, counterclockwise to
lower it
8. When finished, re-tighten lock nut ( Figure 14 ).
Figure 14
Hex nut Lock nut