9
Step 6.1: Install TPMS bracket
A. Attach the provided TPMS bracket to the rear of the cab in your previously selected location. Be
sure the TPMS antenna will protrude below the bottom of the cab
Step 6.2: Attach TPMS antenna to bracket
A. Loom TPMS cable enough to reach to cab access hole.
B. Attach the TPMS antenna cable to the bracket and tighten.
TIGHTEN: Finger tight + 1 turn
C. Attach the TPMS antenna onto the cable then carefully tighten.
TIGHTEN: Finger tight + 1/4 turn, until snug.
The TPMS antenna
must be oriented pointing DOWN-
WARD to ensure good reception
from the TPMS sensors.
TPMS CABLE ROUTING GUIDELINES
• Do not bend or stretch antenna cables too tightly when routing.
• A
minimum bend radius of 1" for TPMS
must not be violated to prevent signal transmission issues.
• When routing the cables avoid sharp edges that may cut or abraid the cable or heat sources that may melt the cable.
• Do not use adhesive cable tie mounts on curved surfaces. Only attach them to clean, flat surfaces.
SECTION 6. MOUNT TPMS Antenna
Test fit the TPMS antenna prior to attaching bracket
to make sure it will protrude past the bottom of the cab and will
not contact anything, even when cab airbags are deflated.
TIGHTEN:
Finger tight + 1 turn
with 5/8" wrench
TIGHTEN:
Finger tight + 1/4 turn
with pliers
TPMS