5
GPS
Transmissions are blocked by
metal, but will pass through
fiberglass, plastic, or glass.
Preferred Location:
Top faring bracket or roof
Alternative Location:
Top of dashboard
SECTION 3. PLAN COMPONENT InstallATION
GPS Antenna
TPMS
POWER
GPS
Preferred Source:
Inverter power & ground studs
Alt. Source 1:
Direct to battery
Alt. Source 2:
Fuse panel
Power Source
TPMS Antenna
TPMS Antenna
Gateway
Cable routes & cab acess hole
GATEWAY
Gateway power source should be:
• Continuous, 12V or 24V power source
• Grounded to the vehicle chassis
• Find an existing cab access hole, or a location to
make a 1/2 inch hole, to route the external cables to
the inside of the cab.
• Power harness and externally mounted antennas
must have enough length to reach the gateway.
• Excess cable put into service loop and stored in an
open volume behind a trim panel or other safe spot.
• Right, Left, or Center of cab
• Points DOWNWARD
• Protrudes below bottom of cab
• Does not contact anything when
cab airbags deflated.
GPS Antenna on top fairing bracket
min. 6" from vertical metal
Antenna performs best in
horizontal orientation
Preferred Location:
Under sleeper bunk
Alternative Location:
Behind seat
on B pillar panel