Apec Water ESSENCE ROES-PHUV75, Installation Instructions & Owner'S Manual

Page: 24 / 44

21
4) Important! Make sure the “double-ring” end of the membrane goes into the housing first as shown in
Fig.15B . The membrane cannot filter water if it’s inserted in the WRONG direction!
5) Close the housing cap. Reconnect the WHITE tubing to the cap. Turn on the cold water supply and tank
valve. Let the RO system run to re-fill the tank (takes about 2-3 hours).
6) Check for leaks!
7) Drain the first tank of water (through faucet) to flush out the new membrane! The 2
nd
tank of
water is ready for use.
How to Replace Stage-5 UV Bulb:
Replace the UV light bulb after 1 year of service. After 12 months, the UV bulb loses its strength.
Pro-longed use after 1 year will result in less than optimal performance.
1) Unplug the light Transformer from the power outlet.
2) Do not open the UV light housing.
3) Remove the UV transformer cover from the UV light housing. ( Fig. 15C ).
4) Remove the old UV bulb from transformer cover and install the new bulb ( Fig. 15D & Fig. 15E )
5) Insert the UV bulb all the way into the UV light housing securely and make sure the cover fully covers the
UV light entry point ( Fig. 15F ).
Fig. 15C
Fig. 15D
Fig. 15E
Fig. 15F
21
4) Importan ant! t! M M ake sure the “double-ring” end of th th e e me membrane goes into the housing fi i rs rst t as as s s h hown in
Fig.15 5 B B . Th T e membrane cannot filter water if it it ’s ’s i i ns ns erted in the WRONG direction!
5) Cl Cl os s e e the housing cap. Reconnect the WHI HITE TE t t ubing to the cap. Turn on the e co co ld ld w w at at er supply and tank
va va lv lv e. Let the RO system run to re-f f il il l l th the e ta an nk (takes about 2-3 hours).
6 6) Check for leaks!
7) Drain the first tank of water (through faucet) to flush out the new membrane! The 2
nd
tank of
water is ready for use.
How to Replace Stage-5 UV Bulb:
Replace the UV lig g ht ht b bul u b after 1 year of service. After 12 2 mo mont nt hs, the UV bulb loses its strength.
Pro-longed use e a aft fter er 1 year will result in less than optim mal al p pe erformance.
1) Unplug g th the e li li gh g t Transformer from the power out ut le le t. t.
2) Do o no no t t open the UV light housing.
3) 3) R R em em ove the UV transformer cover fro rom m th th e e UV light housing. ( Fig. 15C ).
4) Remove the old UV bulb from tra a ns nsfo former cover and install the new bulb ( Fig. 15D & Fig. 15E )
5) Insert the UV bulb all th e e wa way y in in to the UV light housing securely and make sure the cover fully covers the
UV light entry point ( Fig. 1 15F 5F ) ).
Fi Fi g g. 15C
Fig. 15D
Fig. 15E
Fig. 15F