12
Balance Control
This control offsets the post-fader signal between the left-Right mix bus pairs. When at the center, detente
position, both sides are fed equal amounts of signal (each down by 3dB). This Balance control has no effect on
the Center mix bus.
Solo Switch (Internally Illuminated when activated)
When pressed, this latching switch will route the channels stereo signal to the Solo system (located in the
Master section). This switch illuminates when activated.
High-Frequency Level Control (Shelving)
Adjust the left and right high frequency boost/cut b/- 8 dB; there is a detent at the center “0”
position. Boost or cut of the high frequency level control is usually used for minor tonal adjustments and
should be used sparsely for best sonic results.
Low-Frequency Level Control (Shelving)
Adjust the left and right low frequency boost/cut b/- 8 dB; there is a detent at the center “0” position.
Boost or cut of the high frequency level control is usually used for minor tonal adjustments and should be used
sparsely for best sonic results.
High Pass Filter Switch (Illuminated when active)
Inserts a high pass filter at 40 Hz at a roll off rate of 18dB per octave for both sides (L & R) of the channel path.
This switch is used to remove unwanted signal content below 40 Hz such as any rumble that may be part of
source material. This results in a clearer signal that reduces low frequency buildup in an audio system, which is
often perceived as a muddy signal.
