18
BASIC TROUBLESHOOTING GUIDE
PROBLEM 1: THE UNIT HAS NO POWER
1. Check if the unit is switched ON.
2. Check the fuse. Replace with the same type if fuse is blown.
3. Check the power cord and make sure there are no disconnections.
4. Verify that the unit is properly connected to the power source.
PROBLEM 2: TEMPERATURE DISPLAY IS ALWAYS ABOVE 500
o
C
Description:
Constant display of above 500
o
C temperature from the
panel C3 then displays a blinking “OFF” on display panels C2 and C3
after a few minutes.
SOLUTION:
The thermal sensor may be broken and needs to be replaced.
PROBLEM 3: ACTUAL AIR TEMPERATURE IS NOT INCREASING
Description:
Actual temperature reading is not increasing or
decreasing based on desired level (set temperature). The panel will
then display a blinking “OFF” on display panels C2 and C3 afterwards.
SOLUTION:
The heating element may be broken and needs to be replaced.
PROBLEM 4: BANNER OR PRODUCT NAME IS ALWAYS SCROLLING
THE UNIT IS NOT USABLE
Description:
The product name is just always scrolling from the digital
panel, rendering the device unusable.
SOLUTION:
Press “Reset” from the panel. Note that resetting the
device will also reset all previously defined configurations. If the
problem persists, contact the vendor.
3
PACKAGE INCLUSION
Main Station
Hot Air Gun and
Hot Air Gun Holder
Soldering Iron with
Smoke Absorber
Power Cord
G001 IC Popper
3017J Filter
Pads
（
6 pcs.
）
Soldering Iron
Holder with
Solder Wire
Stand
Suction Vacuum Cap
Filter Vacuum Cap
Air Nozzles
(1124, 1130, 1196, 1313, 1197)
