10
OPERATING GUIDELINES
5. Set the desired air temperature using buttons A6 and A7.
6. You may start reworking as soon as the desired temperature is
reached. Refer to display panel C3 to verify.
7. When reworking is completed, turn off the
“SMD Rework”
function switch. The autocooling functionality will commence if
the system detects a temperature higher than 95°C. It will blow at
full speed to accelerate the cooling down of the hot air gun. The
autocooling functionality will stop when the temperature of the
hot air gun reaches about 95°C or below, as shown from the
actual temperature display panel, C3. The system will then switch
off and display an “OFF” message from userdefined temperature
display panel, C2.
NOTE:
Make sure the smoke absorption functionality is switched OFF when
using the equipment for SMD Rework.
SOLDERING IRON
1. With the unit plugged to the main power source and main power
switch in the ON position, ensure that the soldering iron is
properly connected to the receptacle, D1.
2. The soldering iron display A3 will show the word “OFF” indicating
the soldering iron function is turn off.
3. To use the soldering iron turn ON the
“Soldering Iron”
function
switch, B1.
4. The soldering iron display A3 will briefly show the current set
temperature then switch to displaying the actual temperature.
5. When we use the adjustment knob, A3, to set the desired
soldering temperature. The digital display A2 will show the
current set temperature based on the knob position.
11
OPERATING GUIDELINES
5. After a few seconds the digital display A2 will switch to showing
the actual temperature. You may start soldering when the desired
temperature has been reached. The small dot located at the end
of the number displayed in A2 signifies the heater regulation.
When the small dot starts blinking on and off the system has
reached the desired set temperature.
6. After usage turn off the soldering iron function switch.
7. If the soldering iron tip is still higher than 100 degrees, the
soldering iron display will show the word “Hot” indicating the
soldering iron is still hot to caution users.
8. When the soldering iron tip’s temperature has fallen to
manageable level the display will show the work “OFF”
9. Switch ON the
“Smoke Absorber”
power switch, B2, to activate
the smoke absorption functionality.
NOTE:
Turn the “Smoke Absorber” ON only after the soldering iron reached
the desired (set) temperature. This is to avoid affecting the temperature
increase of the soldering iron in terms of heating time.
SOLDERING IRON SLEEP TIMER
1. The soldering iron has a sleep feature that allows the soldering
iron to go into sleep mode depending on user programmed
duration.
2. To access and enable the sleep feature of the soldering iron:
●
Turn Soldering iron, SMD and Smoke absorber function switch off.
●
Press and hold the hot air temperature increase button A6.
●
The soldering iron display A2 will turn to “t##” , indicating it is
now on sleep timer adjustment mode.
●
Turn the soldering iron adjustment knob to select desired sleep
time in minutes.
