Hardware Installation
2-4
2.2
Jumper Settings
Board jumpers are made of pin headers and plastic connecting caps. These
are included in the mainboard design to enable you to customize your
hardware. The onboard jumpers are normally set to its default and optimum
setting. Be sure you have basic knowledge of computer hardware and
understand the function of the jumper before you change any setting.
Pin 1 of a jumper is indicated by a bold line on the mainboard. You may also
find number indications on the board to specify the proper configuration of the
jumper.
To set a jumper, simply connect the plastic cap to the required pins. For
example, to set a jumper to 1-2, place the plastic cap on pins 1-2 of the
jumper. An OPEN setting means that no plastic cap connected to the jumper
pins.
1
2
Open
1
2
Short
1
2
3
Jumper set at 1-2
1
2
3
Jumper set at 2-3
Summary of Contents for AP5VM
Page 1: ...AP5VM PART NO 49 87530 021 DOC NO AO094 9704B...
Page 2: ......
