Hardware Installation
2-21
Multifunction Connector
The multifunction connector is a 20-pin
connector marked
CN14
on the board.
Attach the green mode LED, keylock,
reset switch, turbo switch, and turbo LED
connectors onto the corresponding pins
as shown in the figure.
( Turbo Switch ) ( Turbo LED )
Break Switch Green Mode LED
Reset
Speaker
Power LED
Keylock
Some housings have a five-pin connector
for the keylock and power LED.
Speaker
Keylock & Power LED
Break Switch
Green Mode LED
( Turbo Switch )
( Turbo LED )
Reset
Other housings may have a 12-pin
connector. If your housing has this type
of connector, plug it onto CN14 as shown
in the following figure. Make sure that
the red wire of the connector connects to
pin 11.
( Turbo Switch )
Break Switch
Ground
VCC
Ground
Ground
Keylock
Reset
Res-VCC
Speaker
