AODELAN E3+, Manual

Page: 41 / 56

39
2. Set the channel and ID
Set the channel by pressing function button 2 corresponding to
,
turn < > to select the channel and press < >button. You also choose
to scan the radio reception status and set the master unit’s transmission
channel automatically or manually. For operation please refer to preceding
wireless setting section.
Set wireless radio ID: Press function button 3 corresponding to ,
turn < > to select the digit to be set, and press < > button. Again turn
< > to select a number from 0-9, and press the < > button. Repeat
the procedure to set the 4 ID digits one by one. Press function button 4 for
corresponding to to return to the shooting-ready state.
3. Set the camera’s shooting functions
4. Set all the transmitters
Repeat steps 1to3 and set all the transmitters to “Master unit” or “Slave unit”
in the linked shooting mode.
Set the Speedlites used in linked shooting in the same way.
When pressing linked shooting button to change the setting of a unit from
“Slave unit” to “Master Unit”, the other transmitter (or Speedlites) that were
set to “Master Unit” until then automatically switch to “Slave unit.
5. Set up the slave unit cameras
Check that the < > lamp of the slave unit lights green and place all the
slave units within master unit’s the radio transmission range.