Model 32L31F\32L41F
Document No.
ITBC0101
Version
v5.0
Panel K320WD1 series
Effective from
2012-11-1
Date Updated
2012-11-1
NO
Amount
Diagram
Tool Parameters
1
7002-32L31F-C4B00013
1
32L31F\32L41F black back cover
Figure 1/2
Electric screwdriver
2
7030-420L31-4U711101
1
42L31 black button array
Figure 3
3
±
0.5kgfcm
3
7B11-0306A4-00101111
2
Figure 3
4
9014-112L31-00001011
1
32-42L31 key board
5
Prepared by
Reviewed by Approved by
Xu Sijun
Φ
3
×
6mm flat-head flat-tail nickel-plated tapping
screws
Project Controlled Seal
Station Name
Back Cover Processing-1
Part Number
Figure:
1. Wastes produced by this station shall be placed in the assigned position. Refer to
Waste Classification and Disposal List
.
2. Install screws by the serial number (install one by one) and abnormalities such as screws being neglected, tilted and slipped are not allowed.
Notice
Fit key board to the key properly.
Recent
Modification
Record
Section/Serial No.
Descriptions
Preprocessing 01
When finished, step on the switch with your foot to send the product to
next station.
Operations and Requirements
Fit button array to back cover properly as illustrated.
Fasten key board with two screws.
1
2
Interface face
down.
Figure 1
1
Figure 2
Figure 3
Process Requirements:
1. Check for rusted screws, missing
slots or bad cross slot.
2. Check if the electric screwdriver
torque force is within the specified
requirements.
3.When installing screws, align the
electric screwdriver and the screw to
the screw hole vertically (do not tilt).
4. In the process of installing screws,
properly exert pressure to make a
close contact between electric
screwdriver and screw slot to avoid
slipped screw.
5. Put the defective screws in the
defective product box and do not
throw them at will.
Please read and understand the
operating instructions carefully
Take only
one screw
at a time
Summary of Contents for LE32W234DL
Page 32: ...Operation Instructions ...
