W2
W1
Step 2
1.Measure the finished opening width at the
bottom("W2") and at the model height("W1").
IMPORTANT: No need for cutting if the
Support Bar[02] and the Bottom Rail [03]
match the width.
If they don’t, please see
Step 2.2 for cutting instructions.
2.Using a pencil or another marking tool
(such as masking tape), mark distance
"W1, subtract 1-1/8"(28.5mm) "
on the
Support Bar[02]
( to leave some space
for the
Wall Bracket
),
"W2, subtract 1/16"(2mm)
on the
Bottom Rail [03]
( just in case the end of the
rail can't match the corner of the wall so well).
IMPORTANT: Double check the
measurements before cutting.
Cut the
Support Bar[02]
and the
Bottom Rail[03]
with a fine toothed (32 TPI) hack saw.
If needed, use a metal file to smooth rough
edges. Clean up metal shavings.
DO NOT stand on or use a vice to hold the
Support Bar[02] and the Bottom Rail [03]
while cutting.
W1
, subtr
act
1-1/8"
[
02
]
[
03
]
[
02
]
x1
[
03
]
x1
W2
, subtr
act
1/16"
Fig4
8
Summary of Contents for SD-FRLS05901 Series
Page 26: ......
