QC-6601P Rev 1.0 Page 6
Installation
Initial Start Up
To prepare your
QC-6601P
for use, you need to:
1.
Unpack the equipment supplied. Open the cabinet door and remove the 2 square head screws
that hold the machine to the pallet, these are located in the front right hand corner and rear left
hand corner of the base of the machine looking in from the rear. Use a magnetic screwdriver
to avoid dropping the screw and washer into the bottom of the machine.
2.
After feeding the power cord through the cable entry in the base of the machine plug the cord
into the internal three pin socket on the power supply. Plug the other end into a standard mains
supply outlet. Use the P-clip supplied to strain relief the power cord.
3.
Plug your network cable into the RJ45 network socket after feeding through the cable entry in
the base of the machine as above.
4.
Switch the unit on using the Mains Switch on the Power Supply Front Panel
5.
Fit printer paper if not pre-loaded. (See section later in this manual)
6.
Reset the Long and Short term meters through the Configure System option in the
Configuration Menu accessed via the web interface. (See section later in this manual)
7.
At the machine load tokens via the Refills option in the machine Attendant display menu. (See
section later in this manual)
