ACT-5X+ Exciter User Manual
Version 1.1 5/8/2015
Page 27 of 33
Note:
1)
Do not change the connection status during the ADPC process otherwise it may affect the
performance.
2)
If any abnormal situation occurs during the ADPC process, the system will bypass all the
pre-correction data immediately and leave the corresponding status on the front panel LCD. Press any
key to cancel the ADPC function manually and restart the ADPC function again after the problems are
resolved. Refer to Chapter 5 for further information.
Tx
Antenna
RF_OUT
Power
Amplifier
Band-pass
Filter
ATSC Exciter/Translator
After BPF
RFINA
RFINB
Attenuator1
Attenuator2
Before BPF
R
F
O
U
T
Transmitter
Figure 1 Connection with Transmitter of UPDATE Function
4.3 Connections for TSoIP (option)
The (optional) TSoIP module enables the Exciter to receive a transport stream through an IP network.
Connect your IP stream to the Exciter rear panel TSoIP RJ-45 rear port connection as shown below.
1)
Connect to the TS IP network by connecting the TSoIP RJ45 port on the Exciter back panel.
The TSoIP module converts the IP stream to ASI and feeds the corresponding ASI stream back out the
exciter rear panel TSoIP OUT BNC connector. Connect a BNC-to-BNC jumper cable to bring this ASI
stream back into the Exciter at the desired ASI input as shown below.
2)
Connect the TSoIP OUT BNC port to TS IN 1A or TS IN 1B on the back panel through a RF cable
with 2 BNC male connectors
TSoIP input stream from Mux
