ACT-5X+ Exciter User Manual
Version 1.1 5/8/2015
Page 18 of 33
4)
The “MUTI” submenu defines the multicast address of the TSoIP module; this will only be valid
when TSoIP module is set to multicast (TYPE set to MULTI under MISC submenu) mode.
5)
The “MISC” submenu defines the miscellaneous settings of the TSoIP module, see Table 13.
Table 13 MISC Menu
PORT
TYPE
LEN
PROTOCOL
Default
04321
MULTI
188
UDP
Options
*****
UNI
204
RTP
Note:
1)
The “PORT” parameter specifies the UDP or RTP port from which to receive the transport packets
2)
The “TYPE” parameter specifies in which method the transport packets are received, MULTI refers to
multicast; UNI refers to unicast
3)
The "LEN" parameter specifies the transport packets length in bytes, choices are 188 or 204
4)
The “PROTOCOL” parameter specifies the internet protocol used to transport the packets, the
supported protocols are UDP or RTP
Table 14 PAC Config Menu (only applicable in RF AGC mode)
Welcome to Config PAC interface!
IP
GATEWAY
MASK
Default
192.168.001.200
192.168.001.001
255.255.255.000
Options
***.***.***.***
***.***.***.***
***.***.***.***
Note:
1)
The "IP" submenu defines the physical IP address of the connecting Anywave power amplifier.
2)
The “MASK” submenu defines the network mask of the connecting Anywave power amplifier.
3)
The “GATEWAY” submenu defines the network gateway/route of the connecting Anywave power
amplifier.
