14
7
Shortcut Operations
Channel Scan
DCS SCAN
FM radio
Under channel mode,this operation can be temporarily used by
user. Once the radio is turned off or switched to another channel,
the temporary setting will be erased. If the channel setting
programmed for valid, the temporary setting will keep valid until
next change, turn off radio or switch to another channel, the
temporary setting will not changed.
FM radio adjusting step size is 50Khz, and scan step size is
100Khz.
Press
FUN
SET
then press
FM/H·L
to switch among
high , middle, low power level , the LCD
displays current power level.
Displays
HI
: transmit by high power level.
Displays
MI
:
transmit by middle power level.
Power level control
DCS code: 000N-777I total 1024 groups,
N is positive code, I is inverse code. Press
V/M
to to choose positive code or inverse
code.
Press any key except
4.
VOL+
/
VOL—
or
SC/SKP
key to exit scan.
Repeatedly press
DCT
until LCD displays
TSQ. Press
SC/SKP
to enter CTCSS scan mode,
Once finding a mathcing CTCSS signaling, it
will stop for 15S then scan again. Press any
key exit.
Repeatedly press
DCT
until LCD displays
TSQ. Press
SC/SKP
to enter CTCSS scan mode,
Once finding a mathcing CTCSS signaling, it
will stop for 15S then scan again. Press any
key exit.
Press to switch between FM radio and two
way radio mode.
In FM radio mode:
Press
1.
V/M
to switch between frequency mode and channel mode.
Press
2.
/
/
MHz
to change frequency or channels. (Refer
to page 11, Adjusting Frequency/Channel)
Press
3.
SC/SKP
to start FM radio frequency or channel scan. (page 13,
Frequency/Channel Scan)
Press
4.
FUN
SET
and
V/M
to store or delete a channel. (Refer to page 12,
Channel Edit/ Channel Delete)
Press
5.
VOL+
or
VOL—
to adjust volume level. (Refer to page 11,
Adjusting The Volume)
In FM radio mode, you can setup resume method when radio receive
6.
any valid radio singal)
Press
A.
, the LCD displays S, when
receiving valid radio signaling, the LCD
displays radio interface but the FM radio
still on.
Press
B.
, the S disappears from the LCD, when receving valid
radio signaling, the radio will exit FM radio mode and switch to
radio interface.
