Manual Anytec 868 CAB
2017 (REV A)
Anytec Sweden AB
Magasinsgatan 7
903 27 UMEÅ
0770-220 210
- 12 -
3.14 Fire extinguisher
The fire extinguishing equipment consists of one handheld extinguisher of powder type,
mounted on the steering console.
O- check the fire extinguisher at regular intervals to make sure it can operate at full power
It is the responsibility of the owner / user:
to ensure that the fire extinguishing equipment is working;
to ensure that the crew know where the fire extinguishing equipment can be found and
how it is to be used;
W- Make sure that you never;
position anything in a manner which would impede access to safety functions such as :
switches for the electrical system, the main switch; - modify any part of the boat
systems (particularly its electrical and fuel systems);
fill the fuel tank while the engine is running, or near to a naked flame;
smoke when handling any kind of fuel.
O - The fuel tank is located under the aft deck. Should a fire occur in this space there is a fire
port installed for rapidly injecting extinguishing the fire extinguisher in the space. Make sure
you know where the port is located
3.15 Bilge pump system
This system comprises two bilge pump with an automatic level switch. It is located in the
stern and can handle water in excess of 10 l.
Bilge pumps can also be operated manually. The switches are located on the console to the
left of the steering wheel. This boat comes equipped with a manual hand pump. A hose is
located on the bottom at the stern and allows you to drain all water from the boat. If you take
the boat up on land, you have to undo the boat plug in the stern. Do not forget to refit it once
the boat has been emptied
This boat is self-bailing by means of straight aluminium pipes which are located at floor level
and pass straight through the stern.
W- Check regularly to make sure that no refuse or other waste has entered the PVC hose and
could cause a blockage. This is particularly important in autumn when leaves, etc. fall.
O- Check the pump function at regular intervals. Clear dirt / refuse out of the intake screens.
It is important to ensure that the power supply to the pump has been disabled via the switch
so that the pump does not continue to operate without any water or after inspection.
https://www.boat-manuals.com/
