14
P/N 1011369 Rev. B 07/17
Problem
Possible Cause
Corrective Action
Crowns and/or Heels must be forced
into the toaster. Buns sticking and
burning.
Silicone Belt not being cleaned properly.
Clean Silicone Belts as described in the
Maintenance section of this manual.
Silicone Belt are not tacky/sticky (replace every 2–4
months).
Clean Silicone Belts. If the Silicone Belts are too
worn, replace them as described in the Maintenance
section of this manual.
Silicone Belt are dirty, worn, or damaged (replace
every 2–4 months).
Clean or replace Silicone Belts as described in the
Maintenance section of this manual.
Release Sheet is not being cleaned properly.
Clean both sides of the black and silver Release
Sheet as described in the Maintenance section of
this manual.
Release Sheet is not being reversed as required.
Reverse the Release Sheet or replace Release Sheet
as described in the Maintenance section of this
manual.
Release Sheet is dirty, worn, or damaged (replace
every 3–5 weeks).
Clean or replace the Release Sheet as described in
the Maintenance section of this manual.
Conveyor Belt Chain is skipping on Sprockets.
Measure and adjust the Conveyor Belt Chain as
described in the Maintenance section of this
manual.
Silicone Belts slipping over Conveyor Belt Chain.
Remove Silicone Belts and clean the Conveyor Belt
Chain links and Silicone Belts as described in the
Maintenance section of this manual.
Drive Motor stalls intermittently.
Contact your maintenance person or an Authorized
Service Agency for service.
Compression Settings are incorrect.
Use the recommended settings.
Buns are not inserted into the toaster properly.
Buns must be inserted with the cut sides facing
down on the correct Heel or Crown side.
New Silicone Belts do not fit.
Compression Settings are incorrect.
Set Bun Thickness Compression Knobs to 1 when
replacing Silicone Belts or when adjusting the
Conveyor Belt Chain.
Silicone Belts not installed correctly.
Install Silicone Belts between the Support Rods with
the zipper flap exposed and facing up.
Silicone Belts are damaged or are the wrong type for
your unit.
Replace with 7001256.
Toaster makes unusual sounds.
Compression Settings are too tight.
Set Bun Thickness Compression Knobs to the
correct (or larger) setting.
Silicone Belts are installed incorrectly.
Silicone Belts must be installed as described in the
Maintenance section of this manual.
Silicone Belt Pin rubbing on housing.
Center the Pin in the Silicone Belt zipper.
Conveyor Belt Chain has stretched.
Measure and adjust the Conveyor Belt Chain as
described in the Maintenance section of this
manual.
Conveyor Belt Chain adjusted incorrectly.
Sugar and/or carbon has accumulated inside the
Silicone Belt and between the Conveyor Belt Chain
and Tensioner Slide Rails.
Remove Silicone Belts, clean Conveyor Belt Chain
links just as you clean the Silicone Belts daily, and
then clean the Slide Rails on the Tensioners. Next,
clean the Silicone Belt on both sides before
reinstalling it.
Motor Drive Chain needs lubrication.
Lubricate the Drive Chain carefully with Lubit-8 (P/N
2140152) at least once a year.
A Conveyor Shaft bearing is binding.
Contact your maintenance person or Authorized
Service Agency for service.
TROUBLESHOOTING (continued)
