Antunes 9210912, Owner'S Manual

Page: 5 / 20

Installation
Unpacking
1. Remove unit and all packing materials
from shipping carton.
2. Open the included large box. It
should contain the following (See
Figure 2):
• Bun Chute
• Bun Feeder
• Two guttered Release Sheets
• Platen Cleaning Tool
• Owner’s Manual
• Maintenance Card
3. Remove all shipping tape and
protective coverings from the unit and
parts.
NOTE: Missing or damaged parts?
Contact Antunes Customer
Service at +1-877-392-7856 (toll
free).
Rear
Conveyor
Cover Hinge
Insert Bun Chute
through front of unit.
Bun Chute is properly
installed when it hangs
from the rear Conveyor
Cover hinge.
Figure 1. Bun Chute Installation
Equipment Setup
Before placing the toaster into
service, pay attention to the following
guidelines:
y
Make sure power to the
unit is off and the toaster
is at room temperature.
y
Do NOT block or cover any
openings on the unit.
y
Do NOT immerse cord
or plug in water.
y
Keep cord away from
heated surfaces.
y
Do NOT allow cord to hang
over edge of table or counter.
y
Connect the unit to the
proper power supply. Refer
to the specification plate
for proper voltage.
NOTE: The factory has pre-installed
a Release Sheet over the
Platen (Figure 2). Verify that
it is properly in place before
proceeding.
Installing Butter Wheel
Assembly
1. Remove Butter Wheel and Pan from
box.
2. Install the Pan over the front edge of
the Heat Shield and place the Butter
Roller in Pan and engage into gear
case (Figure 2).
3. Fill the Butter Pan with Butter before
toasting.
Installing the Bun Chute
1.
If the unit is on, be sure to put on heat
resistant gloves.
2.
Insert the Bun Chute through the front
of the unit according to Figure 1.
3.
Hang the back of the Bun Chute on
the rear Conveyor Cover hinge. When
properly installed, the Bun Chute
supports will be flush against the front
of the unit (Figure 1).
NOTE: You may need to stand to the
side of the unit to guide the Bun
Chute into place from the front
and rear using both hands.
IMPORTANT: Make sure Heat Shield
assembly is activating the
Conveyor Interlock Switch
(Figure 2). The conveyors
will not rotate unless the Heat
Shield is in place and Conveyor
Interlock Switch is activated.
®
P/N 1011376 Rev. D 11/20 5