13. ASSIGN MENU
Assign menu is accessed by long pressing button B, B1
and B2 LEDs light up. You can switch between CV assign-
ment (B1 & B2 LEDs) and pot assignment (B3 & B4 LEDs)
by pressing button B while in this mode. Leave this page
by long pressing on button B again.
On both pages you can set which parameter is controlled
by CV (coming in on the CV input jack) and pot 10.
If both of them are assigned to the same parameter, pot
10 acts as an offset to the CV signal.
Assignable parameters:
1 Step (0-8):
sets the current step to given value.
2 Gate length (1-95%):
sets gate length.
3 Sequence length (0-8):
sets sequence length.
4 Pause (0-1):
pauses sequence when input is high.
Summary of Contents for ROT8
Page 1: ...ANTUMBRA ROT8 MANUAL ...
