12. BUILD
18. Place the 10mm spacer in the middle hole on top.
Depending on the type of your spacer, screw in a
screw, or add a nut to hold it in place.
19. Now place the front panel on top, screw in the screw
in the top hole as illustrated and tighten all the nuts.
You might have to adjust the encoder so that it’s
barely in the holes of the PCB but don’t worry about
it, the most important thing is that it is screwed tight
to the panel! (you can add washers under it to in-
crease the distance.)
You can adjust how much the leds peek out, I usually
just put a tape over the panel so that the LEDs are in
level with the holes.
18
19
