ANTTI Plug&Dry, Installation And Operating Instructions Manual

Page: 7 / 59

Antti-Teollisuus Oy 7 408116 03-2020
Weight of the dryer's components:
2W 3W 4W
Base 725 kg 900 kg 1320 kg
Section (2 pcs, without air channel ends) 1080-1190 kg 1520-1635 kg 1960-2115 kg
Top section 220 kg 280 kg 355 kg
Top section with cover and handrails 400 kg 520 kg 655 kg
Please observe, when lifting the heavy components of the dryer:
- use all the lifting lugs on the components
- use the lifting lugs and a bracing when lifting the ready-assembled top tank
- ensure that the lifting hooks stay in position in the lugs, and that the crane being used is sufficiently powerful
- never go under or too near the components to be lifted
- the crane must be able to lower the component to be lifted slowly and precisely into position
- reserve 3–5 tools that can be used as guide pins such as, for example, pin punches of 5–8 mm in diameter
Provide all the horizontal seams with sealing band.
Note! If you wish to stack several sections, and lift them on top of the base in one go, use the separate lifting lugs
(501010). Refer to the erecting instructions 408076 for detailed instructions. Attach the lifting lug by eight M8
bolts. Brace the lugs by fixing battens of 50x100 by the two holes to support the lugs so that the section end will
not bend. Use the same lugs for lifting the top tanks.
The dryer can be assembled from larger sub-assemblies. All the drying sections and the top tanks can be lifted
into place using the robust lugs on the top. The maximum load, allowed to be lifted is 6,750 kg An example: the
top tanks and the top tank cover with handrails can be assembled while the section is still on the ground. Tighten
all the bolts – use M10 bolts for fixing the vertical supports. Lift this large sub-assembly on top of the base or the
lower-lying sections.
NOTE!
The total weight of the sub-assembly is several tonnes, so a heavy crane is required. Verify the load-bearing ca -
pacity of the soil, before the lifting.