ANTTI Plug&Dry, Installation And Operating Instructions Manual

Page: 38 / 59

Antti-Teollisuus Oy 38 408116 03-2020
A73996
Attach the divider to the conversion part of the elevator, and install the bearer for the wire control pulleys at the
side of the divider. Connect the wires to the control levers of the divider, and on one side, route the wires directly
to the lower control unit, and on the other side, route them via the eyebolts to the other control lever, avoiding too
sharp angles. See drawing: "Operating principle of the wire control"
Install the circulation pipes between the elevator and the dryer. Make sure that the fall angle of the piping is 45° (1:1).
Operating principle of the wire control
Wire control of the 3-way divider