Antec Scientific DECADE II 171, User Manual, Page: 75 / 87

CHAPTER 10 Error messages 75
C H A P T E R 1 0
Error messages
Table X. Error messages.
Error Message
01 Incompatible boot version
02 Control board error
03 Sensor board x error (x = board number)
04 Firmware program error
05 Record error
06 Incompatible FW version
07 Incompatible FW
08 Control board FW erase failed
09 Sensor board x
10 Upload checksum error.
11 Checksum error.
12 Temperature sensor 1 error.
13 Disconnect flow cell x
14 Control board SRAM error.
15 Sensor board x SRAM error .
Please contact your local supplier if one of the above errors occur.
Furthermore the following messages can be displayed on the LCD screen
during a measurement:
Table XI. Messages.
Message Advice
01 Out of range Output is either above +1.0V or below
–1.0V.
Pressing AZERO may give an adequate read-out
again. If the message remains after pressing
AZERO, the autozero function is unable to
compensate the background cell current. Advice:
use a less sensitive range in the SETUP menu.
02 PAD overload Charging current in pulse mode out of range.
Pressing AZERO may give an adequate read-out
again. If not, it is advisable to change the pulse
settings (increase t1) or use a less sensitive range.