4
Operation
♦
Add fluid carefully to the liquid tank. Do not overfill the tank.
♦
Plug the remote control cord into the slot marked remote control on the back of the machine.
♦
Plug power cord into a grounded electrical outlet. Turn the power switch to “
ON
” on the back of the machine.
The red light on the remote will turn ON once the machine is plugged into a power outlet and the ON/OFF
switch is turn ON. The unit will take a couple of minutes to warm up the heater. During this time the machine
cannot generate fog. The green light on the remote will turn ON once the machine is ready to produce fog.
♦
To emit fog press the green button on the remote. Z-1200II is controlled via the Z-8 remote control.
♦
For detailed instruction on the various functions on operating your Z-1200II Fog Machine, see the section titled
“
Remote Control Operation
”.
Important:
Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can
permanently damage the unit.
If your model includes a mounting bracket designed for overhead installation, it may be installed
floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that
the fog does not shoot directly at any one’s face. Whatever installation method you choose, do not
allow the unit to have more than a 15 degree angle or onclination.
Note:
A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than the
maximum level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the
external fuse, remote control connection and power from the wall. If all of the above appears to be O.K.,
plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check the
hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine
the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit.
Return the machine to your ANTARI dealer.
Specification
Model Number
Z-1200II
Power Supply
AC100-120V, AC220-240V / 50HZ-60HZ
Power Consumption
1250 W
Output Volume
ca. 500 m³/min.
Tank Capacity
2.5 Liter
Fluid Consumption
44 min./Liter
Weight
10.9 Kg.
Dimensions(mm)
L458 W243 H177
Remote Included
Z-8
Remote Control Operation
♦
Z-8:
10 meter wired multi-function remote control with 5-PIN plug for ANTARI Fog Machine model
Z
-1200II.
The
Interval
knob adjusts the time between discharges when the timer function is engaged. The range is from
10 seconds to 250 seconds.
The
Volume
knob controls the volume of the fog produced. The range is from 0% - 100% of maximum output.
The yellow
TIMER
button controls the timer function. Depress the button to activate. When activated, the
yellow light will turn ON. Adjusting the interval knob will determine the time between fog output (10 – 250
seconds). The duration of output is set at 15 seconds. The volume can be adjusted using the volume knob to
control the amount of fog produced.
Summary of Contents for Z II Series
Page 17: ...17...
