3
Danger of Burns
♦
For adult use only and must be installed out of the reach of children. Never leave the unit running unattended.
♦
Never aim the output nozzle directly at people.
♦
Fog machine output is very hot. Avoid coming within 60 cm of the output nozzle during operation.
♦
Locate the fog machine in a well-ventilated area. Never cover the unit’s vents. In order to guarantee adequate
ventilation, allow a free air space of at least 20 cm around the sides and top of the unit.
♦
Never aim the output nozzle at open flames.
♦
If the supply cord is damaged, it must be replaced by manufacturer or its service agent or similarly qualified
personnel in order to avoid a hazard.
♦
The output nozzle becomes very hot during operation (300°C). Keep flammable materials at least 50 cm away
from the nozzle.
♦
Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it.
Danger of Explosion
♦
Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
♦
Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause
clogging or “spitting”.
♦
Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage to
the pump as well as over-heating of the heater.
♦
If your ANTARI Z-1200II Fog Machine fails to work properly, discontinue use immediately. Drain all fog liquid
from the tank, pack the unit securely (preferably in the original packing material), and return it to your ANTARI
dealer for service.
♦
Always drain tank before mailing or transporting this unit.
♦
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or eyes,
rinse thoroughly with water.
Note:
Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The
shipping carton should contain the following items:
1. One unit of Z-1200II Fog Machine
2. Power
cord
3. Z-8 multi-function remote control with attached cord
4. User
Manual
If any equipment is missing contact your ANTARI dealer immediately.
Before beginning your initial setup on ANTARI Z-1200II Fog Machine, make sure that there is no evident damage
caused by transportation. In the event that the unit’s housing or cable is damaged, do not plug it in and do not
attempt to use it until after contacting your ANTARI dealer for assistance.
Setup
♦
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
♦
Place fog machine on a flat surface and remove fog liquid tank cap.
♦
Fill with ANTARI fog liquid or other high-quality water-based fog fluid recommended by ANTARI dealer. Any
other types of fluid can damage the unit resulting in spitting and serious clogging problem. When filled, place
cap back on liquid tank. Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
♦
Firmly attach the Z-8 remote control cable to the proper input on the back of the machine.
Summary of Contents for Z II Series
Page 17: ...17...
