2
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system
has arrived intact. The S-100 should come with the snow machine, remote control, fluid
tank and hanging bracket. Accompanying the S-120 foam machine should be a hanging
bracket and fluid tank. If any equipment is missing contact your ANTARI dealer
immediately.
Before beginning initial setup of either the ANTARI Snow Machine or the ANTARI Foam
Machine, make sure that there is no evident damage caused by transportation. In the
event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to
use it until after contacting your ANTARI dealer for assistance.
Setup
♦
Remove all packing materials from shipping box. Check that all foam and plastic
padding is removed, especially in the nozzle area.
♦
Place the machine on a flat surface and remove the liquid tank cap.
♦
Fill with ANTARI SL-5 Snow/Foam Liquid, ANTARI SL-5A Premium Snow Liquid
(snow machine only) or other dealer-recommended high-quality water-based snow or
foam fluid. Any other types of fluid can damage the unit. When filled, place cap back
on liquid tank.
♦
For the snow machine, firmly attach the 3 pin connector on the remote control cable
to the proper input on the rear of the machine.
Snow Machine Operation
♦
Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit
to ”ON” position.
♦
To emit snow, press the appropriate button on the remote for the desired length of
time.
♦
Two pilot lamps on the remote control indicate power and operation status.
♦
Use the adjustable knob on the remote control to regulate the volume of snow output.
Foam Machine Operation
♦
Plug power cord into a grounded electrical outlet. Turn the power switch on rear of
unit to the "ON" position.
♦
The machine will begin producing foam as soon as it is turned on. To stop the foam,
turn the power switch to the “OFF” position.
Both the snow machine and the foam machine may be installed floor level or
suspended overhead. When mounting the unit overhead, it is important that the snow
does not shoot directly at anyone’s face. Whatever installation method you choose, do
not allow the unit to have more than a 15 degree angle of inclination.
Important
: Always monitor tank fluid level during operation. Running a snow machine
or a foam machine without fluid can permanently damage the unit.
