Antaira Technologies - Industrial Ethernet Switches
LNP-0500G-bt-24 Series User Manual V1.1
10
The following figures show the cabling schematics for straight-through and crossover cables.
2.9 Cabling
Twisted-pair segments can be connected with an unshielded twisted pair (UTP) or shielded
twisted pair (STP) cable. The cable must comply with the IEEE 802.3u 100Base TX standard
(e.g. Category 5, 5e, or 6). The cable between the equipment and the link partner (switch, hub,
workstation, etc.) must be less than 100 meters (328 ft.) long.
2.10 Wiring the Power Inputs
Please follow the below steps to insert the power wire.
1. Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-) contacts
on the terminal block connector as shown below in
Figure 2.6
.
2. Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in
Figure
2.7
.
Figure 2.7
Power Terminal Block
Figure 2.6
Power Terminal Block
Figure 2.4 - Straight-Through Cables Schematic Figure 2.5 - Crossover Cables Schematic
