G.FIT User Guide and Specification, Rev 2.0_Alpha.14
Page 109 of 117
thisisant.
com
B.3.1.1
G.FIT
This shows which G.FIT module the simulator is connected to. If there is more than one G.FIT module
connected to the computer, then select which module to use.
B.3.1.2
Equipment type
This setting determines which type of fitness equipment is simulated.
B.3.1.3
HR selection type
Select the pairing mode used to connect the heart rate monitor to G.FIT. See section 4.2 for more details on
the best choice for the given use case.
B.3.1.4
RSSI thresholds
When pairing to a heart rate monitor using proximity mode, the simulat or will pair with a heart rate monitor
automatically based on the proximity to G.FIT. See section 4.2.1.1 for more details on selecting RSSI values.
The RSSI values shall be set so that Pairing < Searching.
B.3.1.5
Configuring FE metrics
Specific field IDs will need to be selected appropriately depending on which fitness equipment type is set. For
details on the setting FE metrics see section 7.3.11. For a list of field IDs for the given fitness equipment
type see section 7.3.11.2.
B.3.1.6
Auto configuration
This provides the quickest and easiest method of configuring the FE metrics for the given type of fitness
equipment. Ensure that the Auto config checkbox is selected as in Figure B-8. When selected, the simulator
will configure every FE metric listed in the appropriate table (section 7.3.11.2) for the given fitness
equipment type. Press the ‘Apply G.FIT Setting Button’ seen in
Figure B-7 to complete G.FIT configuration.
Figure B-8. Auto configuration of FE metrics
B.3.1.7
Manual configuration
If you would like to simulate a type of fitness equipment that does not fully support all types of FE metrics,
then manual configuration is required. Manual configuration allows the user to individually select the FE
metrics that will be supported. To use manual configuration, ensure that the Auto config checkbox is
deselected as in Figure B-9. Field IDs can then be selected to configure which FE metrics G.FIT will support.
It is important to select the proper field IDs for the given type of fitness equipment (see section 7.3.11.2).
When a field ID is selected, verify that it was sent properly and that there were no errors returned. When
finished configuring the FE metrics manually, press the ‘Apply G.FIT Setting Button’ seen in
Figure B-7 to
complete G.FIT configuration.