ENGLISH
89
Parameter setting
When the appliance is in standby mode, press
,
and
for 3 seconds to enable the
parameter setting mode. Use
and
to select the parameter to be changed and press
to
enable setting mode. The value flashes on the display. Set the required value with
and
and
confirm the setting with
.
You can cancel the parameter setting with
or by not pressing any buttons for 20 seconds.
Parameters
Significance
Range
Standard setting
1
High fan speed in cooling mode
450
–2000
1400
2
Medium fan speed in cooling mode
450
–2000
1200
3
Low fan speed in cooling mode
450
–2000
1000
4
High fan speed in heating mode
450
–2000
1250
5
Medium fan speed in heating mode
450
–2000
1000
6
Low fan speed in heating mode
450
–2000
750
7
Super low fan speed in heating mode
450
–2000
550
8
Water valve
0: without
1
1: with
9
Memory
0: with
1
1: without
Error messages
The following error messages can be given, for example as a result of a sensor fault.
1.
The error code E0 is shown for a communication error between circuit board och control panel.
2.
The error code E1 is shown for a fault on the sensor for input air temperature when there is no
room temperature control.
3.
The error code E2 is shown for a fault on the sensor for input water temperature when there is no
limit on the input water temperature.
4.
The error code E3 is shown for a fault on the sensor for output water temperature when the
appliance continues to work.
5.
The error code E4 is shown for a fault on the fan motor, or if the fan motor cable is not correctly
connected.
Summary of Contents for 416-111
