EN
14
LUX – TO ADJUST THE BRIGHTNESS
This dial is used to set the brightness at which
the detector switches on the light. With the dial
set to the sun symbol the light goes on both
during the day (bright surrounding light) and
night (poor surrounding light), and with the
dial set to the moon symbol the light only goes
on at night. To correctly set the brightness,
wait until the surrounding light reaches the
required brightness. Turn the dial all the way
to the moon symbol. Now turn the dial slowly
back to the sun symbol until the movement
detector switches on the light. The light will
now switch on when movement is detected
and the surrounding light is the same as or less
than the brightness setting.
FIG. 10
SENS – DETECTOR SENSITIVITY
The sensitivity of the detector varies with the
ambient temperature. The sensitivity is higher
at low ambient temperature. The detector is
most sensitive when the
SENS
dial is turned all
the way to (+).
FIG. 11
FIG. 12
FIG. 13
OVERRIDING THE DETECTOR
1. Activate detector override.
FIG. 14
2. Deactivate detector override.
FIG. 15
5. Connect the live wire
L
(brown), neutral wire
N
(blue) and earth wire (yellow/green).
FIG. 5
6. Fit the cable grommet.
FIG. 6
7. Put the power switch in the
ON
position.
NOTE:
The product is only intended to be mounted
on a wall. The maximum mounting height is
3 metres.
USE
• The product can be angled down at 90°
and angled up at 70°.
FIG. 7
• The detector can be turned 70° to the
right and left, and up 90° and down 80°.
FIG. 8
• There are three control dials for the
infrared detector.
–
TIME
– To set how long the floodlight
stays on.
–
LUX
– To set the brightness of the
floodlight.
–
SENS
– To set the sensitivity of the
detector.
TIME – TIME SETTING
This dial is used to set the time the light
stays on after the last detected movement.
The time interval is 10 seconds to 5 minutes.
Turn the dial clockwise for shorter time and
anticlockwise for longer time.
FIG. 9
