Anritsu MP1632C, Operation Manual, Page: 86 / 127

65
7. Sets the method of flow control by selecting it from the Flow Control drop-down list box.
Xon/Xoff Implements flow control using the Xon/Xoff characters, in addition to the
RS-232C control line.
Hardware Implements flow control using the RS-232C control line.
None Do not implement flow control.
8. The RS-232C setup procedure is now complete. Click OK to enable the settings.
6.3.3 Setting GPIB
Procedures for selecting the GPIB remote control interface are described below.
1. Select GPIB from the Remote drop-down list, and the GPIB group box will open on the 'Sys-
tem:System' panel.
2. Click the Setup button in the group box. The GPIB dialog box will open.
When using SCPI commands, select SCIP from Command Type option switch. In this case,
GPIB Address must be within 1 to 30.
Fig. Fig. Fig. Fig. 6666----7777 GPIB Dialog Box (SCIP GPIB Dialog Box (SCIP GPIB Dialog Box (SCIP GPIB Dialog Box (SCIP))))
3. When using Native commands, select Native from Command Type option switch. In this case,
GPIB Address (Address1) must be within 2 to 28.
The Address2 must be next value of Address1. It will be set to such value automatically.
And, select to which unit is assigned each addresses.
GPIB
GPIB GPIB
GPIB
Address
Address Address Address OK button OK button OK button OK button
Cancel
Cancel Cancel
Cancel
button
button button
button
Command Command Command Command
Type
Type Type
Type