Anritsu MP1632C, Operation Manual, Page: 100 / 127

79
Recovery preparations
Complete the following preparations before beginning software recovery:
1. Connect an external keyboard to the instrument.
The execution of the recovery software requires an external keyboard to be connected to the
keyboard. Connect a keyboard to the rear-panel keyboard connector.
2. Enable booting from the floppy disk at power-on time.
The instrument is normally programmed to boot software from the hard disk when it is turn-
ed on. To carry out recovery, it is necessary to insert the recovery disk into the floppy disk
drive and then start the recovery tool from that disk. To enable booting from the floppy disk
at power-on time, do the following:
[1] Turn on the power. When it beeps, press the S key (letter S) while holding down the
Ctrl and Alt keys. The setup window will open.
[2] Point to the Quick Boot position on the screen. The current setting is Enabled (booting
from the hard disk). Using the + and - keys, change it to Disabled (booting from the
floppy disk).
Note
Do not change any setting other than Quick Boot. Turning off the power will reset the
setup window to its initial status.
SETUP Utitlity
** Standard System Parameters **
Quick Boot Enabled
Fig.
Fig. Fig.
Fig. 6666----21
21 21
21 Recovery Preparations
Recovery Preparations Recovery Preparations
Recovery Preparations
[3] Insert the recovery disk DISK1 into the FDD.
[4] Press the ESC key and then F4. The recovery tool starts from FD and recovery process-
ing begins