Anritsu BTS Master MT8222A, User Manual, Page: 42 / 115

BTS Master UG PN: 10580-00156 Rev. T 3-1
Chapter 3 — Basic Measurement
Setups
3-1 Introduction
This chapter provides a brief overview of the Anritsu MT8222A BTS Master. The intent of
this chapter is to provide a starting point for making basic measurement setups. This chapter
describes setup, configure frequency, bandwidth, and amplitude before configuring your
measurement setups. After measurements are taken, refer to section
“Managing Files” on
page 4-1 for a description of saving, recalling, and deleting measurement files. For more
detailed information about specific measurements, refer to the measurement descriptions in
the measurement guides for the specific instrument mode and analyzer technology (such as
WiMAX or 3GPP). Refer to
Appendix A, “Measurement Guides” , for a list of these guides and
their Anritsu part numbers.
3-2 Measurement Setup
Connect the Input Source
Connect the input signal or antenna to the appropriate test connector on the top of the
instrument. For connector descriptions, refer to
Figure 2-12 on page 2-14 .
Editing and Entering Values
• Parameter values that are ready for editing are displayed in red on the submenu key.
After changing the value, press
Enter
to set the new value.
• Some submenu keys have toggled parameter values (
On / Off, Low / High
). On these
submenu keys the current value is underlined. Press the submenu key to toggle the
value.
• Use the arrow keys, numeric keypad, or rotary knob to change submenu key values,
to select list box options, or to enter filenames.
Selecting the Analyzer Mode
1. Press the
Shift
key followed by pressing the
Mode
(9) key on the numeric keypad to open
the Mode Selector list box.
2. Use the directional arrow keys or the rotary knob to highlight the desired mode, and
press the
Enter
key or the rotary knob to select.