Anritsu BTS Master MT8222A, User Manual, Page: 41 / 115

2-12 Firmware Overview Instrument Overview
2-18 PN: 10580-00156 Rev. T BTS Master UG
Hold
The BTS Master is on hold. To resume sweeping, toggle from
Hold
to
Run
in the Sweep menu.
Single Sweep
Single Sweep is selected. Press
Continuous
sweep to resume sweeping.
2-12 Firmware Overview
Main Menu Keys
The BTS Master menu-driven interface is easy to use and requires little training. The
5 Main Menu keys are located below the measurement display. These 5 keys are used to list
function-specific menus in the active menu (submenu labels). These Main Menu keys vary in
function based on the selected mode of operation (
Shift, Mode
(9)). Refer to
“Mode Selector Menu” on page 2-6 for more information on changing the instrument mode.
Table 2-1 lists the Main Menu Key labels for each mode of instrument operation.
Submenu Keys
The 8 submenu keys are located to the right of the measurement display. They change
function depending upon the current mode and current menu selection. The current submenu
title is shown at the top of submenu key labels. Refer to
Figure 2-2 on page 2-3 .
Table 2-1. Mode-Dependent Main Menu Keys Located Below Measurement display
Mode Key 1 Key 2 Key 3 Key 4 Key 5
Cable & Antenna Freq/Dist Amplitude Sweep/Setup Measurements Marker
Spectrum Analyzer Freq Amplitude Span BW Marker
Interference Analysis Freq Amplitude BW Measurements Marker
Channel Scanner Scanner Amplitude Custom Scan Measurements
Vector Signal
Generator
Freq Amplitude Setup Modulation RF On/Off
Power Meter Freq Amplitude Average Limits
High Accuracy
Power Meter
Amplitude Average Zero/Cal Limit
GSM/GPRS/EDGE Freq Amplitude Setup Measurements Marker
WCDMA/HSDPA Freq Amplitude Setup Measurements Marker
TD-SCDMA/HSDPA Freq Amplitude Setup Measurements
LTE Analyzer Freq Amplitude Setup Measurements Marker
CDMA Freq Amplitude Setup Measurements Marker
EVDO Freq Amplitude Setup Measurements Marker
Fixed WiMAX Freq Amplitude Setup Measurements
Mobile WiMAX Freq Amplitude Setup Measurements Marker
DVB-T/H,
DVB-T/H SFN
Frequency Amplitude Setup Measurements Marker
T1/FT1, E1, T3/T1/FT1 Configuration Pattern/Loop Error/Alarm Measurements Start/Stop