17
8.5 Stand-alone mode
Use this menu to run a program or to set a running program in the stand-alone operation - operation without
connected DMX controller
Auto
---
Presetting playback
.This function allows you to select the program which will be played continuously
in a loop after switching the fixture on.The fixture has four freely-programmable programs (EPG1-EPG4) and
five built-in programs (PrG1-PrG5).
OFF
--- The option disables "Auto" function.
tSt
--- The option starts test program
EPG.1
--- The option starts editable program No.1
:
EPG.4
--- The option starts editable program No.4
PrG. 1
--- The option starts built-in program No.1
:
PrG. 5
--- The option starts built-in program No.5
PLAY
---
Playing program
.Select this menu to run a desired program immediately.
EPG.1
--- The option starts editable program No.1
:
EPG.4
--- The option starts editable program No.4
PrG. 1
--- The option starts built-in program No.1
:
PrG. 5
--- The option starts built-in program No.5
Select the program you wish and press [ENTER].The selected program starts running.By Pressing [ENTER]
again is possible to pause the program running.
8.6 Special functions
Use this menu for special services.
VErS.
---
Software Version
.Select this function to read the number of the fixture software version.
tEmP.
---
Fixture temperature
.This item indicates temperature inside of the ArcPower 16x6.
bALA.
---
Balance
.Select this function to enable (On) or disable (OFF) the white balance which is set in "White
colour balance" menu below.If this function is set OFF,ArcPower 16x6 will use maximum value (255) of satura
-
tion for red, green and blue channels.
CALi.
---
LED intensity calibration
.The menu allows you to adjust the max. light intensity of individual LEDs
(colour channels),e.g. the light intensity of all red LEDs connected to the channel 4.This action is suitable in case
that adjacent LEDs (e.g. in LED array) have a different light intensity (but these LEDs have to be connected to
the different zones of the ArcPower 16x6).
Use [UP] and [DOWN] buttons to select desired LED,press [ENTER] and adjust suitable light intensity (0-255)
using [UP] and [Down] buttons,confirm by pressing [ENTER].This adjusted light intensity is its maximum intensity
which can be reached if dimmer=255 DMX. After calibration all LEDs, select
Stor.
to save adjusted values.
COMP
.- Internal calibration.The function eliminates random light flashes during slow dimming.The
calibration action lasts cca one minute.
The COMP function should be performed:
- once after connecting all LEDs to the fixture (after complete installation)
- if the load has been changed (e.g 6-LEDs modules have been replaced by 3-LEDs)
- after software upgrade or changing dimmer characteristic (SPEC--->CHAr)
C.bAL.
---
White colour balance.
Using this menu you can set white balance:
1.
Set all red,green and blue channels on maximum saturation(255)
2.
Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows "
C.bAL
."
menu.Press [ENTER] button and
"rEd.b."
will appear on the display.
3
.Press [ENTER] button again and use [UP] and [DOWN] buttons to adjust the new maximum value required
for the red channel.Confirm your choice by pressing [ENTER].Use the [UP] and [Down] buttons to select next
colour.
Summary of Contents for ArcPower 16x6
Page 1: ...Version 1 1...
Page 21: ...21...
